Owner's Resources
※ Download: Mercury outboard manual by serial number
We will then arrange for the inspection and any covered repair. Clean and wax often using marine cleaners and waxes. Bigfoot Models 260 ml 8.
Although you have a 2003 Model Sterndrive Engine it's the Serial Number that identifies which model of Fuel Cooler your Mercruiser Engine is equipped with. In addition, Mercury Racing, the company's racing division, focuses on powerboat racing and high-performance marine products. Lift rear of cowl and disengage front hook.
Mercury Outboard Motor Service Manual - Remove vent plug from vent hole. Use a Mercury Precision or Quicksilver accessory or equivalent flushing attachment.
Use a Mercury Precision or Quicksilver accessory or equivalent flushing attachment. NOTE: Do not run the engine while flushing the cooling system. Unlock the rear latch by pushing lever down. Lift rear of cowl and disengage front hook. An anode helps protect the outboard against galvanic corrosion by sacrificing its metal to be slowly corroded instead of the outboard metals. The anode requires periodic inspection especially in salt water which will accelerate the erosion. If the filter appears to be contaminated, remove and replace. FUEL LINE INSPECTION Visually inspect the fuel line and primer bulb for cracks, swelling, leaks, hardness, or other signs of deterioration or damage. Place a block of wood between gearcase and propeller to prevent rotation and tighten propeller nut. Secure propeller nut to the shaft with cotter pin. Spark plug Lubrication Points 1. Description Where Used Part No. These points should be lubricated at least once a year by an authorized dealer. Description Where Used Part No. Oil contaminated with water will have a milky color to it; oil contaminated with fuel will have a stong fuel smell. If contaminated oil is noticed, have the engine checked by your dealer. GEARCASE LUBRICANT RECOMMENDATION Mercury or Quicksilver Premium or High Performance Gear Lubricant. CHECKING LUBRICANT LEVEL AND REFILLING GEARCASE 1. Place outboard in a vertical operating position. Remove vent plug from vent hole. Place lubricant tube into the fill hole and add lubricant until it appears at the vent hole. Install the vent plug and sealing washer before removing the lubricant tube.
Check oil level and add oil as needed. Install the vent plug and sealing washer before removing the lubricant tube. These reformulated fuels are acceptable for use in the Mercury engine. Simply enter the original model or serial number assigned to your outboard motor by Mercury Marine. Oils, lubricants or fluids changed as a matter of normal maintenance is customer's responsibility unless loss or contamination of same is caused by product failure that would be eligible for warranty consideration. Evinrude changed how they indicate year in the model number in 1980. Sudden unexpected acceleration could result in serious injury or death. Damage to the charging system may result.
